Table of Contents
Advertisement
Maintainance (General Matter)
How to Maintain Your Refrigerator
Plug the power cord into the outlet.
■ Insert the power plug into the outlet securely, all the way to the end with the power cord facing downward.
NOTICE
● Even if the power plug is plugged in immediately after being unplugged, the compressor will not run for 5 minutes.
However, if the inside is not cold, it will start running in approximately 30 seconds.
● The evaporating tray for defrosting of this refrigerator does not need to be cleaned.
CAUTION
● Do not use the following : An alkaline or weak alkaline kitchen detergent, scouring powder, soap, petroleum, boiling water,
scouring pads, acid, benzine, alcohol, or bleach (for details, see the Caution on the detergent package).
● When any cooking oil, citrus fruit juice, or juice from any food pours on this refrigerator, wipe it off.
● When using a chemical rag, be sure to heed the warnings for rag use.
■ The doors, painted surfaces, and plastic parts may be scratched, or discolored by the chemical rag.
Maintainance (Vacuum compartment)
Pull the vacuum box out
1
In order to take the products stored in vacuum
box (P.16), pull the vacuum box out.
2
For the following part, clean it with a piece of
cloth soaked in warm water.
Aluminum tray
Vaccum box Case
3
Assembly of Vacuum Box Case
Assembly (P.16)
Attach Vacuum Box Case with the core of
Vacuum Box Door.
Vacuum box Case
Core
CAUTION
If the detergent or any product other than warm water
is used for cleaning Vacuum Box Gasket, there may
be effects in terms of deformation, color change or loss
vacuum property.
If Vacuum Box Gasket is dropping or Vacuum Box Door
not well aligned, there may be the loss of vacuum property.
Vacuum box gasket
Gasket
When Vacuum Box Gasket is dirty.
Disassembly of Vacuum Box Gasket
1
out off Vacuum Box Case.
Facing the Vacuum Box, twist the knob
of the Vacuum Box Gasket on top right
and carefully remove.
Knob
2
Wipe gently with sponge on the stain
with plain water.
Don't use any detergent.
Vacuum box gasket
Please clean Packing track also.
3
Wipe water out with dry cloth and leave
the part until it is naturally dried.
4
Assemble Vacuum Box Gasket, twist
the knob to align with the packing track,
deliberately assemble.
Knob
Once a month
Gasket track
Gasket track
25
Advertisement
Table of Contents
