Table of Contents
Advertisement
Preparations before Use
1
Installation
1. Check the width of the doors of the house.
Following shows the installation dimensions for this refrigerator. Be sure to check if you with refrigerator can pass the house doors.
The refrigerator doors may have to be removed if the width or depth of the refrigerator are more than the width of the house doors.
To remove the refrigerator door, please consult with the retailer.
2. Install the refrigerator in the following place.
Install on a rigid and level floor.
● If you install on a such a floor, place a wood board (1cm thick)
and place the refrigerator on the board.
・In case that the floor may be deformed or floor color may be
changed due to a heat from the refrigerator.
・In case of soft or fragile floors on which the refrigerator might incline.
Do not install where the refrigerator is exposed on a direct sunlight or other heat sources.
● Such circumstances may result in poor cooling performance or electricity costs increase.
● Direct sunlight will cause discoloration of the plastic parts of the refrigerator.
Install in a atmosphere which is dry or has air ventilation.
● This helps to avoid rusting and keeps electricity costs down.
* If you wish to install the refrigerator in a hot spring area exposed to sulfide gas,
you may need to apply anti-rust treatment to the piping. Contact your dealer in advance.
A failure caused by that gas damage will not be covered under guarantee.
3. Allow enough space to release heat.
The refrigerator requires enough air ventilation space
around the cabinet to have efficient cooling performance.
● At least 5 cm space must be secured for the left/right,
top and back side of the refrigerator to the wall.
To ensure that the doors can open properly and fully,
make sure that the following space is avilable.
Please check the available space before installation.
4. Earthing wiring.
Ground this refrigerator to prevent electric shock and noise interference.
Always ground this refrigerator when using it in places with high humidity
or moisture. (Please consult with retailers.)
WARNING
5. Adjusting the adjustable legs to keep the left/right
refrigerator door level.
Without adjusting the legs, door height may not be level, or there
may be abnormal vibration or noises depending on floor conditions.
Follow the instructions below.
① Turn the adjustable legs to lower the adjustable
legs until they touch the floor firmly.
② Compare the height of left and right doors and
lower adjustable leg whose door
height is lower than the other until the both door
height become level.
● Turn the adjustable leg for 1 turn makes approx.
1 mm door height change.
● It will take several days until the legs fits the floor
and the door height becomes stable.
In case that the adjustable legs are difficult to turn:
● Remove 2 screws and then remove the adjuster cover.
● Insert a screw driver to a groove of the adjustable
leg and turn.
Remove 2 screws (both sides)
Do not connect the ground line to a gas pipe,
telephone line or lightning rod.
92 cm.
5 cm.
37 cm.
27 cm.
■The left door is lower.
Lower the left adjustable leg
1 cm.
5 cm.
5 cm.
Fix with earth screws
Earthing Terminal
Earthing cord
Adjuster Cover
Adjustable
■The right door is lower
Leg
Lower the right adjustable leg
179.5 cm.
5
Advertisement
Table of Contents
