Sears C 151 61822 4 Owner's Manual page 10

Install the spring (item 1)
# Item Description
1 Spring
NOTE: The latch must move freely.
NOTE: Use these same instructions for both
sides of tractor.
Manual Clutch: Install the new belt guides (item A)
that are included with the drive mechanism on the
bottom carriage bolt (item 1). Choose hole A1 or A2
that best suits to guide the belt around the engine
pulley. Place a 1/2'' flat washer (items B & C) over
the belt guide and the top carriage bolt. Continue with
the handle support installation.
Electric Clutch: Do not install belt guides. Place a
1/2'' flat washer (item B) over the bottom carriage
bolt. Continue with the handle support (left side)
installation and cab support (right side).
Install the handle support (item 2) on the left side and
the cab support on the right side as shown.
# Item Description
1 Carriage bolt
3/8 x 1'' (qty 4)
2 Handle / cab support
**3 Thread cutting screw
3/8 x1''
4 Flat washer 3/8''
(qty 4)
5 Flange nut 3/8''
(qty 4)
6 Square head set
screw 5/16 x 1/2''
7 Plastic grommet
** Use this screw if the bottom hole is threaded.
ASSEMBLY
Action
Install the spring
on the frame as
shown.
Action
Insert the bolts as
shown.
Install as shown.
See **
Install as shown.
Tighten the nuts.
Insert in the hole of
the handle.
Insert as shown.
8
Install the spring as shown
Install the handle support on left side
Install the cab support on right side