5> Flow Adjustment In High Temperature Segment - S&A CW-6000AN250S01 User Manual

7. Advanced parameters adjustment cases:
Order Code
Temperature
1 F0
Temperature
2 F1
Difference values
3 F2
4 F3 Way of control
Alarm for over high
5 F4
water temperature
Alarm for over low
6 F5
water temperature
Alarm for over high
7 F6
Room temperature
8 F7
The allowed highest
9 F8
water temperature
The allowed lowest
10 F9
water temperature
(1) Case 1: cooling water temperature is controlled by constant mode. Requiring
water temperature is constant in 28℃, and the fluctuate does not exceed ± 2℃.
The alarm of over high water temperature will be on when water temperature is
5℃ higher than normal value, and the alarm of over low water temperature will
be on when water temperature is 10 ℃ lower than normal value. It is
convenient for user to adjust the water temperature between 5-30℃.
(2) Case 2: cooling water temperature is controlled by constant mode. Requiring
water temperature is constant in 20℃, and the fluctuate does not exceed ± 1℃.
The over high water temperature will be on when water temperature is higher
than 25℃, and the alarm of over low water temperature will be on when water
temperature is lower than 5℃. (Regardless of what is the ambient temperature,
the cooling water temperature is constant in 19℃ to 21℃)
<5>
Flow adjustment in high temperature
segment
After long-term testing, 1～1.5 L/min flow rate in high temp segment is the best for
cooling laser optics.
Value in
Item
case 1
28
setting
Cooling
2.0
hysteresis
10
45
Password
30
CW-6000/6100/6200 Series
Value in Temperature
case 2
controller
Factory Setting
20
1.0
0 0
5 4
14
45
8 8
30
5 5
9
T-506 T-506H
Temperature
controller
Factory Setting
30 25
-2 -2
0.1 0.3
1 0
10 10
15 15
45 45
8 8
35 30
20 20