Install The Sliding Rail Assemblies; Install The Server - Dell EMC VxFlex Ready Node 13G Hardware Installation Manual

1U1N Configuration Equipment Installation

Install the sliding rail assemblies

Hardware Installation Guide
34
Figure 11 Install the server
This procedures describes installation of the sliding rail assemblies in the cabinet.
Procedure
1. Position the left and right rail end pieces labeled FRONT facing inward and
orient each end piece to seat in the holes on the front side of the vertical
cabinet flanges (1).
2. Align each end piece in the bottom and top holes of the desired U spaces (2).
3. Engage the back end of the rail until it fully seats on the vertical cabinet flange
and the latch clicks into place. Repeat these steps to position and seat the front
end piece on the vertical cabinet flange (3).
Note
To remove the rails, pull on the latch release button on the end piece midpoint
and unseat each rail (4).