Epson PowerLite 503c Quick Setup

Locate everything
you'll need
For this setup, you'll need just these two cables:
power cord computer cable
You won't need to install any software.
Connect the projector
to your laptop
1
Make sure your projector and laptop are turned off.
2
Connect one end of the computer cable to
the Computer port on the projector.
Connect the other end to your laptop's video or
3
®
to your PowerBook , you may need to use an adapter. See your User's Guide for instructions.
Plug in your projector
Connect the power cord to your projector and plug the other end into a grounded outlet.
Pop out the lens
Rotate the lens ring to pop out the lens,
then squeeze the tabs to remove the lens cap.
Turn on your equipment
1
To turn on the projector, press the red Power button.
The power light flashes green, and then stays on.
2 Turn on or restart your laptop. (Windows
this Add New Hardware screen, click Cancel.)
EPSON

Quick Setup

monitor port. If you can't connect the cable
Power button
®
only: If you see
® PowerLite ® 503c/713c
Follow these
instructions to
connect your laptop
to the projector.
To connect other
devices, such as a VCR
or desktop PC, see
your User's Guide.
Caution: Before unplugging
the projector...
To shut the projector down properly:
1. Press the red Power button twice.
Let the projector cool while the
light flashes orange (about a minute).
2. Once the light stops flashing and stays
on, it's safe to unplug the projector.
Never unplug the projector when the
power light is green or flashing orange.
The power light
turns orange.
squeeze here
power
Turn Over