Connection To The Control Unit - TEXA TXB EVOLUTION Manual

10.4 Connection to the Control unit

To carry out the self-diagnostic tests you must connect the device to the
vehicle's diagnostic socket and activate the connection between the device and
the control unit through the software.
Proceed as follows:
1. Using the software, select the vehicle and the system on which you wish to carry
out the self-diagnosis.
Locate the diagnostic socket using the information (images or short video)
2.
provided by the software.
3. Connect the tool to the control unit using, where needed, the specific cables
and adapters indicated by the software. .
A flashing green LED indicates that the vehicle's control unit and the device
are communicating correctly.
The position of the diagnostic socket on the vehicles varies according to the
make and model; this is why the software provides the information needed to
locate it.
Follow the instructions provided by the software carefully.
If not specified otherwise, power the tool directly by connecting it to
the vehicle's diagnostic socket.
For further information consult the software's Operating Manual.
en
31