Prior To Operation; Switching On And Off - Stanley STDH7213K Manual

power tool is powered off and the power plug of the
tool is unplugged from the power source.
b
Selecting the operating mode (fig. B)
The tool can be used in two operating modes:
q
Rotary drilling:
for steel, wood and plastics.
Impact drilling:
simultaneous rotating and impacting for
concrete and masonry drilling operations.
Select the required operating mode by rotating
u
the mode selector (4) to the required position.
Inserting and removing a bit (fig. A)
Keyed chuck
Open the chuck by turning the sleeve (9) coun-
u
terclockwise and insert the bit shank.
Put the chuck key (10) into each hole in the
u
side of the chuck and turn clockwise until tight.
To remove the bit, proceed in reverse order.
u
Fitting the side handle (fig. A)
The side handle (6) can be fitted to suit both
RH- and LH-users.
Always use the drill with the side handle
properly assembled.
Loosen the side handle.
u
For RH-users, slide the side handle clamp over-
u
the collar behind the chuck, handle at the left.
For LH-users, slide the side handle clamp over-
u
the colar behind the chuck, handle at the right.
Rotate the side handle to the desired position-
u
and tighten the handle.
Setting the drilling depth (fig. C)
Insert the required drill bit into the chuck.
u
Slacken the side handle (6).
u
Fit the depth adjustment rod (7) through the
u
hole in the side handle clamp.
Adjust the drilling depth as shown.
u
Tighten the side handle.
u
Forward/reverse slider (fig. A)
To select forward or reverse rotation, use the
u
forward/reverse-switch (3) (see arrow on tool).
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
Chuck removal (fig. D)
Open the chuck jaws as far as possible
u
Insert a screwdriver into the chuck and remove
u
the chuck retaining screw (12) by turning
clockwise.
Tighten an Allen key into the chuck and strike it
u
with a hammer as shown.
Instructions for use
Always observe the safety instructions and ap-
u
plicable regulations.
Be aware of the location of pipework and wir-
u
ing.
Apply only a gentle pressure to the tool.
u
Excessive force does not speed up drilling but
decreases tool performance and may shorten
tool life.
Wear ear protectors with impact drills.Exposure
u
to noise can cause hearing loss.
Use auxiliary handles supplied with the tool.
u
Loss of control can cause personal injury.
Hold power tool by insulated gripping surfaces,
u
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power
tool "live" and shock the operator.
If operating a power tool in a damp location
u
is unavoidable, use a residual current device
(RCD) protected supply. Use of an RCD re-
duces the risk of electric shock.

Prior to operation

Insert the appropriate bit.
u
Mark the spot where the hole is to be drilled.
u
Proper Hand Position (fig. A, E)
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper hand
position as shown.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the
side handle (6), with the other hand on the main
handle.

Switching on and off

To switch the tool on, press the variable speed
u
switch (1). The tool speed depends on how far
you press the switch.
For continuous operation, press the lock-on but-
u
ENGLISH
7