Advertisement
Unlock
When Using DLVI
To Red Lock Wire
Of Control Module
Green
X
Blue
To Green Unlock Wire
Cut and Splice
Of Control Module
Per the Install
Guide Instruction
When Using Relays
To Red Lock Wire
Of Control Module
To Red/Black 2nd
Unlock Wire Of Control Module
To Green Unlock Wire
Of Control Module
NOTE: Resistive Circuits, Multiplex Circuits As Well As 4 Wire Polarity Reversal and 5 Wire
Alternating 12 Volt Door Lock Control Circuits
These applications require the use of additional components which may include relays, fixed resistor, a
door lock interface, or a data module. You can search the vehicle @ www.avxtech1.com, Flash-It.com for
vehcile specific information, or contact our tech service line or web site for additional information.
Additional Harnesses And Connectors For The System
4 Pin Upgrade Telematic Module:
Red = + 5 Volts / Black = Ground / White = Data TX / Yellow = Data RX
Connect the 4 pin harness found in the Telematic one way or Carlink II kits to the mating port on the
controlling circuit.
NOTE: If using the TWO WAY Telematic module, only Ground, TX, and RX are used on this port, the +
12 volt supply for the two way module must be sourced separately or the unit will not operate.
6 Wire Antenna/Transceiver Program Push-Button Switch/LED Connector: Part # 1124293
Plug the previously routed antenna connector from the antenna transceiver assembly into the mating
connector of the control module. This connector supplies 5 volts, ground and RF data input and output,
LED cathode, and Valet Enable to and from the antenna transceiver and the remote start module. Be
certain this connector is firmly seated making good contact to the control unit.
Positive Switch Driver Priority
85
87a
Lock
30
86
(+)
86
87a
30
85
Factory Lock Relay
85
87a
87
30
86
To Fused + 12 Volts
Fused + 12 Volt Source
85
87a
87
30
86
To Fused + 12 Volts
Factory Unlock Relay
Factory Lock Relay
87
Drivers Door Motor
From Vehicle
Chassis Ground
87
Factory Unlock Relay
X
Cut Drivers Door
Unlock Motor Wire
If Factory Switches + 12 Volts
86
87a
87
Connect to Fused + 12 Volt Source.
If Factory switches Ground,
Connect To Ground.
30
85
18
Passenger Door Motors
(Connector Port)
128-9310
18of 30
Advertisement
