Advertisement
To LT Blue, (GWR) Wire
From Multi Pin Harness
86
85
To Fused + 12 Volt Battery Source
D. Anti-Grind Starter Circuit Connection:
This wire, when connected to a starter inhibit relay, as shown in the diagram below, will prevent the
customer from engaging the starter while the vehicle is running under control of the remote start.
The "E" series Alarm/Start units have the Anti-Grind feature built into the module controlled by the
Orange Start Inhibit Output,,,the keyless start units do not and, if desired, will require this circuit.
To LT. Blue Gnd While
Running Wire of Remote Start
3 Black w/ White trace Wire:
The black w/ white trace wire is provided to beep the vehicle's horn. This is a transistorized low current
output, and should only be connected to the low current ground output from the vehicle's horn switch.
If the vehicle uses a + 12 VDC horn switch, then connect the black w/ white trace wire
to terminal 86 of a 30Amp automotive relay, and connect relay terminal 85 to a fused
+ 12 VDC battery source. Connect relay terminal 87 to the vehicle's horn switch output, and connect relay
terminal 30 to a fused + 12 VDC battery source.
4 Purple Wire: (+) Door Trigger Input
If the vehicle's door courtesy light switches + 12 volts when the door is opened, (Some Fords and some
Imports), you must connect this wire to the positive output from one of the vehicle's door pin switches. In
most cases, the Purple wire will need to be connected to only one door switch no matter how many doors
the vehicle has as most door lighting circuits are wired in parallel. This wire will be shunted when remote
starting the vehicle and will remain shunted, if active, while running under command of the remote start.
If this wire is active when the system is armed, the siren will emit three chirps. When the zone clears, the
siren will emit 1 chirp to confirm full arming.
Note: for vehicles with interior delay lighting see programming under title "Completing The Installation"
5 Brown w/ Black trace Wire: Positive Inhibit Input Plus Trigger When Armed
The Brown w/ Black Trace wire provides an instant shutdown for the Remote Start Control module whenever
it gets + 12 volts also triggers the alarm when armed. If the Brake lights switch in the vehicle switches +
87a
87
Matching
Resistor
30
Cut
To Starter Motor
Black/White
X
30
4002 Diode
To Orange Wire
87a
Of Alarm/Remote Start
86
87
4002 Diode
300 mA Horn Output
10
VAT Wire #1
VAT Wire #2
Cut Factory Wire
and route through
relay as shown
VATS Control Module
Existing Low Current
Start Solenoid Wire
From Ignition Switch
Start Terminal
Black
85
To + 12 Volt Ignition / Start
128-9310
10of 30
Advertisement
