Table of Contents
Advertisement
STARTING
Caution
1. Be sure the foot lever is in the lowered
position, causing the diamond grinding disc
to be disengaged from the floor. The image
below illustrates the position that the air lifter
leg pedal should be in before you start the
engine. If you do not disengage the grinding
head from the floor and try to start the
RG1112 will have a tendency to rotate and
could cause injury.
2. Place throttle lever in the choke position if
you are starting a cold engine. If the engine
is warm do not use the choke. Move the
throttle lever slightly past the idle position.
3. Turn the fuel valve to the ON position (shown
below).
4. Pull the starter grip lightly until resistance is
felt, then pull briskly.
KEEP CLEAR OF GRINDING DISC
WHEN STARTING
5. Do not allow the starter grip to snap back
against the engine. Return it gently to prevent
damage to the starter.
6. If the choke was used to start the engine,
move the throttle to the fast or high position
as soon as the engine warms up enough to
run smoothly without the use of the choke.
7. Let the engine warm up at an idle for a
minute or two before you increase the engine
throttle and begin to grind. Running cold
engine a high rmp will decrease the life of
the engine.
9
Advertisement
Table of Contents
