Troubleshooting - Omron M7 Intelli IT Instruction Manual

HEM-7322T-E_D_M.fm Page 30 Friday, July 27, 2018 12:03 PM
4. Error Messages and Troubleshooting

4.2 Troubleshooting

In case of any of the below problems occur during measurement, first check that no
other electrical device is within 30cm. If the problem persists, please refer to the
table below.
Problem
The measurement result is
extremely high (or low).
Arm cuff pressure does not rise.
Arm cuff deflates too soon.
Cannot measure or the results are
too low or too high.
30
Cause
Apply the arm cuff tighter.
Arm cuff is applied too loosely.
Refer to section 3.1.
Remain still and do not talk during
Movement or talking during
measurement.
measurement.
Refer to section 3.3.
Remove any clothing interfering
Clothing is interfering with the arm
with the arm cuff.
cuff.
Refer to section 3.1.
Make sure that the air tube is
The air plug is not securely
connected securely.
connected into the air jack.
Refer to section 3.1.
Replace the arm cuff with a new
one.
Air is leaking from the arm cuff.
Refer to section 5.3.
Apply the arm cuff correctly so that
it is firmly wrapped around the
The arm cuff is loose.
arm.
Refer to section 3.1.
Inflate the arm cuff so that it is 30
to 40 mmHg above your previous
The arm cuff has not been inflated
measurement result.
sufficiently.
Refer to section 3.3.
Solution