Ro Module; Oil Level Control On The High-Pressure Pump; Changing The Oil Of The High Pressure Pump - Kärcher WATERCLEAN 1600 Operating Instructions Manual

MALFUNCTIONS AND MAINTENANCE
4.3.2

RO Module

4.3.2.1

Oil Level Control on the High-Pressure Pump

4.3.2.2

Changing the Oil of the High Pressure Pump

- 86 -
Version 03/2008
Check the oil level of the high-pressure pump through the oil sight
glass (52/2).
If necessary, fill up with oil to the upper edge of the oil level gauge. To
do this, unscrew the Screw (52/1) on the housing cover and pour in
SAE 50 oil.
Fig. 52
1 Screw
2 Oil level gauge glass
3 Oil drain plug
• Remove the housing cover of the high pressure pump according to
Section 4.3.2.1.
• Place an oil pan under the high pressure pump (amount of oil
approx. 2 l).
• Unscrew the oil drain plug (52/3) and drain oil.
• Clean oil drain plug and seal and rescrew again.
• Pour in oil according to Section 4.3.2.1 (approx. 2 l).
1
3
WATERCLEAN 1600
2