Loading Roll Paper - Epson Stylus Photo R1800 Manual

Epson Stylus Photo R1800
8. Open the printer cover and look down into the printer to
make sure the paper is straight; if not, press the z roll
paper button for 3 seconds to back the paper out. Press the
) paper button to clear the paper out error, then load the
paper again.
If crooked, reload
paper
9. Before printing, select
Manual - Roll
(Windows) or
Manual - Roll
(Macintosh) in your printer software.

Loading Roll Paper

You can load 4-inch, 8.3-inch, or 13-inch wide roll paper for
printing multiple photos or panoramics, with or without
borders.
Tip: It's a good idea to check your ink levels before loading and
printing on roll paper. (See page 6.) If you need to replace a
cartridge with roll paper loaded, you should remove the paper or
marks may appear in your printout.
1. Turn on the printer and remove any paper loaded in the
sheet feeder at the top of the printer.
2. If the output tray and extension are open, push them in, but
leave the flap at the end of the tray down.
Epson Stylus Photo R1800
10 -
as the Source setting
as the Paper Source setting
3. Swing out the roll paper guides until they are straight.
4. Place the roll paper on the holders as shown, then remove
the tape and protective paper from the end of the roll.
5. Make sure the end of the paper is cut straight across, with
90° corners. If the end is cut diagonally, you may have
problems feeding the paper.
6. If the paper curls at the end, roll it backwards between a
folded sheet of paper to uncurl it.
Avoid touching the printable surface of the roll paper.
2/05
90°