Loading Paper In The Sheet Feeder - Epson Stylus Photo R1800 Manual

5. Shake the new cartridge four or five times before opening its
package. (Don't shake it after it's unpacked.)
6. Remove the new cartridge from its package.
Caution: Don't touch the green circuit board on the front of
the cartridge; you may inhibit normal operation and printing.
7. Slide the new cartridge into its slot. The side with the green
circuit board goes in the front of the slot.
8. Press the cartridge down until it clicks into place.
9. If you need to replace any other ink cartridges, repeat steps
4 through 8.
10. Close the cartridge cover, press it down on the top until it
clicks, then close the printer cover.
11. Press the H ink button. The printer begins charging the ink
delivery system.
The green P power light and red H ink lights flash and the
printer makes noise. Charging takes about 90 seconds.
When it's finished, the green P power light stops flashing
and stays on. The red H ink light and the light(s) above the
cartridge(s) go out.
Caution: Never turn off the printer while the green
is flashing, unless the printer hasn't moved or made noise for more
than 5 minutes.

Loading Paper in the Sheet Feeder

1. Open the paper support and pull up the support extensions.
2. Push in the bottom of the output tray. The tray opens and
moves up.
3. Pull out the output tray extension.
4. Place your paper in the printer and slide it against the right
side of the sheet feeder.
power light
P
Check the following as you load paper:
❏ Always load the short edge first, even for printing
❏ Load the printable side face up. It's usually whiter or
2/05
Epson Stylus Photo R1800
Output tray
landscape-oriented documents.
brighter than the other side.
Epson Stylus Photo R1800
Output tray
extension
- 7