Hitachi Kokusai Electric KP-FD510WCL Operation Manual page 16

(15) PAINT BLACK : Setting of paint black (color level of R, G, and B can be separately varied).
-MODE- : Select of mode
OFF (Factory setting)
ON
-RED- : Adjust red color level
0 (Factory setting) to 255 : Adjust red color level in 256 steps.
-GRREN- : Adjust green color level
0 (Factory setting) to 255 : Adjust green color level in 256 steps.
-BLUE- : Adjust blue color level
0 (Factory setting) to 255 : Adjust blue color level in 256 steps.
(16) PARTIAL SCAN : Setting about partial scan
-MODE- : Select of mode
OFF (Factory setting)
ON
-START- : Start position of partial scan
1 (Factory setting) to 2050 : Scan is started from the line set up in 1 to 2050.
-WIDTH- : Width of partial scan
1 to 2050 (Factory setting) : Scan is performed number of line set up in 1 to 2050 is scanned.
*Note: When WIDHT is 16 or less, AGC and AES may not operate.
(17) TEST PATTERN ： Setting for the test pattern.
OFF （Factory setting）
H-LAMP
V-LAMP
HV-LAMP
(18) BALANCE ADJUST : Setting for the balance of the right and left screen.
-MODE- : Select mode
OFF
MANUAL
AUTO (Factory setting)
-RIGHT GAIN- : Setting for the gain value of the right screen
-1.1456dB～+1.1456dB
-RIGHT BLACK- : Standard offset setting of right screen
-128/2048～+127/2048
(19) FACTORY SETTING
-SET- : Return to the factory settings.
: Not use paint black functions.
: Use paint black functions.
: Not perform partial scan.
: Perform partial scan.
： Test pattern is OFF.
： Output the horizontal lamp image.
： Output the vertical lamp image.
： Output the horizontal and vertical lamp image.
: No adjustment for the balance.
: Adjustment by the manual operation.
: Auto adjustment for the balance.
: When MANUAL, set this value for the right screen by 64 steps.(Factory setting: 0dB)
: When MANUAL, set this value for the offset of the black level for the right screen by
256 steps. (Factory setting: 0/2048)
8