Delta Industrial 23-710 Instruction Manual page 8

FOR YOUR OWN SAFETY, DO NOT CONNECT MACHINE TO THE POWER SOURCE UNTIL THE
MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
ASSEMBLING AND
ADJUSTING EYESHIELD
1. Position eyeshield (A) Fig. 3, under lip of frame (B).
Line up holes in eyeshield (A) with holes in frame (B)
and fasten eyeshield to frame using two 1/2" long
round head screws (C), flat washers (D) and hex nuts
(E). Place flat washer on round head screw, place
screw through hole and then fasten hex nut to screw
under the frame.
2. Insert short end of eyeshield mounting rod (F) Fig. 4,
into top of frame (B) and fasten in place with the 3/4"
long carriage head bolt (G) and hex nut (H).
3. Figure 5, illustrates the mounting rod (F), frame (B)
and eyeshield (A) assembled.
4. Assemble the long end of eyeshield mounting rod (F)
Fig. 6, to the side of the dry wheel guard using clamp
bracket (J) and lock knob (K). The eyeshield (A) is
fully adjustable to any position by moving shield (A)
or loosening lock knob (K) and repositioning
mounting rod (F).
A
ASSEMBLY
F
J
K
Fig. 6
C
D
E
G
H
B
8
C
B
Fig. 3
F
Fig. 4
B
A
Fig. 5
D
E
A
F