Delta Industrial 23-710 Instruction Manual page 19

3. Place sliding tool rest (G) Fig. 53, onto the tool rest
base (H) as shown.
4. Adjust the height of tool rest base (H) Fig. 54, by
moving locking lever (J) to the right and turning
raising and lowering knob (K) until knife (B) Fig. 53,
lightly touches grinding wheel (L). Then move locking
lever (J) Fig. 54 to the left to lock in place.
5. Check to see if the knife (B) Fig. 53, is parallel with
grinding wheel (L) at both ends when the knife is just
contacting the wheel.
6. If the knife (B) Fig. 53, is not parallel with the grinding
wheel, loosen screw (M) Fig. 55, and rotate tool rest
base (N) until knife is parallel with grinding wheel.
Then tighten screw (M) Fig. 55.
7. Check to see if the bevel edge of the knife (B) Fig. 56,
is flat on the grinding wheel. If an adjustment is
necessary, turn tilting screw (O) Fig. 56, until the
edge of the knife is flat on the grinding wheel.
8. Fig. 57, illustrates a typical grinding operation of a
jointer or planer knife.
O
B
Fig. 56
G
H
H
19
B
L
Fig. 53
Fig. 54
M
Fig. 55
Fig. 57
J
K
N