Delta Industrial 23-710 Instruction Manual page 16

4. Place sliding tool rest (K) Fig. 40, in position on base
(J).
5. Fig. 41, illustrates sliding tool rest (K) in position on
tool rest base (J).
6. To level sliding tool rest (K) Fig. 42, with the wet
grinding wheel, loosen screw (L), rotate complete
tool rest base (E) right or left until tool rest (K) is level
with the wet grinding wheel and tighten screw (L).
7. To raise sliding tool rest (K) Fig. 43, unlock two posts
(M) by moving clamp lever (N) to the right, as shown.
Rotate knob (O) Fig. 44, clockwise to raise, or
counterclockwise to lower the tool rest (K). After the
height of tool rest (K) is set, move clamp lever (N) to
the left in the locked position.
K
N
M
Fig. 43
16
Fig. 40
K
Fig. 41
K
L
Fig. 42
K
N
O
Fig. 44
K
J
J
E