Delta Industrial 23-710 Instruction Manual page 15

3. Remove the tool rest and mounting post (E) Fig. 35,
from the wet wheel side of the machine and insert
post of tool rest assembly into hole (F). Tighten
screw (G) into groove of mounting post. All controls
and adjustments for the tool rest are explained in the
section "ASSEMBLING AND ADJUSTING TOOL
AND CHISEL HOLDER."
4. Figure 36, illustrates a rough grinding operation on a
plane iron (H) using the dry wheel.
ASSEMBLING OPTIONAL
ACCESSORY 23-715 SLIDING TOOL
REST TO WET WHEEL
The 23-715 Sliding Tool Rest is available as an accessory
for your sharpening center and is especially suited for
sharpening jointer and planer knives. To assemble the
23-715 Sliding Tool Rest, proceed as follows:
1. Loosen screw (A) Fig. 37, and remove tool and chisel
holder assembly (B) as shown.
2. Assemble sliding table tool rest base (E) Fig. 38, to
mounting post (A) and tighten screw (F) against
groove (G) in mounting post.
3. Place flat washer, spring and another flat washer
onto the tilting screw knob included with the 23-715.
Thread tilting screw and spring assembly (H) Fig. 39,
into hole in left post.
F
E
G
A
Fig. 38
B
A
15
E
F
G
Fig. 35
H
Fig. 36
Fig. 37
J
H
Fig. 39