Installing In Windows - Epson Stylus Photo 1290 Setup Manual

Installing in Windows

Follow the instructions in this section to install the printer software and
EPSON PhotoQuicker.
Installing the printer software
Follow these steps to install the printer software.
1. Make sure that your printer is turned off.
2. Turn on your computer and start Windows. If the New Hardware
Found dialog box or any other Wizard appears, click Cancel.
3. Insert the printer software CD shipped with your printer in the CD-
ROM drive. The Installer dialog box appears. If it does not, double-click
the My Computer icon, click the CD-ROM icon, then click Open on
the File menu. Then, double-click EPsetup.exe. (For floppy disk users,
insert the disk in a disk drive and double-click the My Computer icon,
then the floppy disk drive icon, and then Setup.exe.)
4. Select Install Printer Driver/Utility, and
click . Then, click OK in the dialog box
that appears to start the printer software
installation. If Problem Solver is available
in your location, it is automatically
installed on your hard drive.
Note:
It is possible to install the Reference Guide
on your hard drive from the Installer
dialog box, as shown to the right. To
install the guide, click Online Guide
and then
screen instructions. When the installation is complete, an ESP 1290 890
Guide icon appears in the EPSON folder. Double-click the icon to open
the guide.
The Problem Solver provides tips and instructions to help you solve most
problems that you may encounter when printing. The Problem Solver can
be accessed through the EPSON folder, Status Monitor 3, or the printer
software. For details, see the "Troubleshooting" section of your Daily Use
guide.
5. Follow the on-screen instructions to turn on your printer.
For Windows Me and 98 users, the printer port configuration starts
automatically.
. Then, click Install Reference Guide and follow the on-