Table of Contents
Advertisement
Wagon Components:
Inspect wagon components monthly. Unusual play or noise could be an indication of worn parts. Parts replacement should
be performed by qualified personnel.
Wagon components should be lubricated / greased yearly, locate the grease zerks shown in the illustrations below.
•
Lubricate with an good Lithium EP2 grease or equivalent.
•
Use a hand-held grease gun for all greasing, one shot of grease is adequate
•
Wipe grease zerk with a clean cloth before greasing, to avoid injecting dirt and grit.
•
Replace broken zerk fitting immediately.
•
If grease zerk will not take grease, remove and clean thoroughly. Also clean lubricant passageway. Replace fittings if
necessary.
On a regular basis check all nuts, bolts
and screws and ensure they are all
properly secured.
Tires: when replacing tires ensure that
your replacement tire matches the type
and specification of the tires that origin-
ally came with the wagon.
Rear Steering Pivot
Ball Joints
smg_body 132
Front Steering
Steering Spindles
smg_body 132
Wheel Bolts: check
on a daily basis.
See wheel torque
Rear View
Steering
Spindles
Pivot
smg_body 132
smg_body 101
Ball Joints
chart
Lightly
lubricate the
tongue lock:
must move
freely
pullout: must
Tire Pressure:
check on a regular
basis: see tire pressure
chart
Front View
CAUTION
!
Operational Hazard
Chock
wheels
when
performing
maintenance
on the wagon to prevent
unwanted movement
CAUTION
!
Operational Hazard
Personal Protection Equipment
(PPE) is required when operating
or maintaining this machine.
Lightly
lubricate
the tongue
move freely
SNL00002
SNL00001
33
Advertisement
Table of Contents
