Table of Contents
Advertisement
Safety Labels
Safety labeling is an important part of the overall safe use of the implement. Safety labeling alerts and warns against
potential injury or death, and is important to follow these points to help keep your implement safe for you and others who
may be using it.
•
Keep safety signs clean and legible at all times.
•
Replace safety signs that are missing or have become
illegible.
•
Replaced parts that displayed a safety sign should
also display the current sign.
Safety Label Descriptions
Caution: read and understand ALL safety and
operating instructions in the manual, read and
understand ALL safety labels located on the
machine. The most important safety device on
this equipment is an informed SAFE operator.
SL00004
Caution: Accidental wagon disconnection on
a public road could result in death or serious
injury and/or implement damage. Before
transport on public roads always have the
safety chain attached, and a 3/4" grade 5 hitch
pin is installed.
SL00005
Caution: an unsecured load may fall from the
wagon and could result in death or serious injury
and/or implement damage. Before transport on
public roads always check the ratchet straps
are tight and in locked position.
SL00006
Caution: Wagon components are rated at 50
MAXIMUM
km/h (30 mile/h) maximum speed. Potential for
50
injury and damage if traveling above maximum
km/h
travel speed rating.
30
mile/h
IL00007
Caution: Do not stand under or directly in front
of the top rail while it is being adjusted, potential
collision exists if the rail drops suddenly and
could result in death or serious injury.
SL00001
If labels need to be replaced:
•
Be sure that the installation area is clean and dry.
•
Be sure temperature is above 50°F (10°C).
•
Determine exact position before you remove the backing paper.
•
Remove the smallest portion of the split backing paper.
•
Align the sign over the specified area and carefully press the small portion with the exposed sticky backing in place.
•
Slowly peel back the remaining paper and carefully smooth the remaining portion of the sign in place.
•
Small air pockets can be pierced with a pin and smoothed out using the piece of sign backing paper.
•
Safety signs in Section 3 each have a part number
displayed with it. Use this part number when ordering
replacement parts.
•
Safety signs are available from your authorized
Distributor or the factory order desk.
Caution: Moving parts present a potential pinch
hazard and could result in a serious injury. Use
caution and be aware of parts as they are being
moved or adjusted.
SL00002
Caution: Loading the header on the wagon
presents a potential pinch hazard and could
result in a serious injury. Use caution and be
aware as the header is loaded on potential
pinch points on the header pads and the top
rail.
SL00003
Caution: Personal Protection Equipment (PPE)
is required when operating or maintaining this
machine. Failure to wear PPE will result in
personal injury.
SNL00001
Slow-moving vehicle (SMV) sign warns other
road users that the wagon displaying the sign
is traveling at maximum road speed of 40 km/h
(25 mile/h) or less. Ensure the sign is in place
whenever transporting on a public road.
Yellow Retro-reflective label required for
marking of implements for length / width.
Red Retro-reflective label required for
marking of implements for length: rear view.
Caution: Block or chock the wheels. Loading
or unloading the wagon presents a potential
unintentional movement hazard. Chock wheels
SNL00002
when loading or unloading or storing the wagon.
11
Advertisement
Table of Contents
