Table of Contents
Advertisement
Look on the LC display of the Emulator. The following message should be displayed:
"BREAK Vol:OK [Enter]:Menu"
Now choose the menu Debug/Run/Go or press F5 or click the
To end debugging, choose Debug/End debug in the Softune Menu Bar. The emulator
system will then halt.
© Fujitsu Microelectronics Europe GmbH
MB2147 – Installation Guide
Chapter 3 Setting up the Emulation Software
Look at the Starter Kit Board. The LEDs of Port0 have
to flash alternately.
The LCD on the emulator should display:
"EXEC Vol:OK [Enter]:Menu"
- 19 -
button.
MCU-AN-390070-E-V29
Advertisement
Table of Contents
