Table of Contents
Advertisement
2.1.8.2 Procedure for Adapter Board MB2147-10
2.1.9 Connect the Probe Cable to the Adapter Board
2.1.10 Connect the Emulator System with the Starter Kit
After inserting, use a small cross tip screwdriver to fix the four screws of the probe cable.
Note: The procedure is similar to a 0.5Om target system
MCU-AN-390070-E-V29
MB2147 – Installation Guide
Chapter 2 Setting up the Emulation System
The procedure is the same like for the
MB2147-20. But pay attention, that Pin
1 mark is turned by 90° clockwise to
the MB2147-20 Adapter Board's mark.
- 14 -
Connect a Probe Cable to the Adapter
Board. For e. g. MB90V390 use the
LQFP120
NQPACK
(MB2132-469).
The cable has to insert in the PROBE CN
A2 (CN1) and PROBE CN A1 (CN2)
connectors on the Adapter Board.
Connect the Probe Cable to a Starter Kit
(e. g. Flash-Can-120-390).
Insert the cable properly into the MCU
socket on the Starter Kit Board. Note, that
it fits only in the correct position: Three
edges of the socket are round and one is
flat.
In
addition both
the
probe
socket
and
the
Board
have small triangles which point to Pin 1.
© Fujitsu Microelectronics Europe GmbH
PROBE
cable
Advertisement
Table of Contents
