Table of Contents
Advertisement
2.1.6 Power connection jumper S1
The power connection jumpers S1 have all to set to A-B for TOOL VCC, P0V and P1V, as
shown below:
All other DIP switches (SW1, P1 SENSE and SW2, P0 SENSE) should be switched off.
Important note: If you are using a 3V system together with an MB90V480 you have to set
the TOOL VCC jumper to B-C (Emulator 5V).
2.1.7 Mount the Adapter Board on the Emulator
2.1.8 Insert the Evaluation Chip
2.1.8.1 Procedure for Adapter Board MB2147-20
right picture and return the lever back in its home position.
© Fujitsu Microelectronics Europe GmbH
MB2147 – Installation Guide
Chapter 2 Setting up the Emulation System
The MB2147-20 Adapter Board has two connectors (ADAPTOR
BOARD CONNECTOR A and B) on the backside witch fit into the
connectors
of
the
MB2147-01.
Pay attention that the small white
triangles
on
the
connectors point together.
Note: The MB2147-10 Adapter
Board is placed in the same way at
the Emulator.
First pull the lever of the Adapter
Board MCU socket. Near the axis of
the lever is a small white triangle,
which points to Pin 1 of the chip
socket.
The Evaluation Chip has a small
golden quadrate on one edge. This
indicates the Pin Position 1.
Then insert the Chip as shown in the
- 13 -
Emulator
side
of
the
MCU-AN-390070-E-V29
Advertisement
Table of Contents
