Install The Network Software; Installing Epson Net!2 In Windows - Epson Stylus Color 850Ne Setup Manual

Note:
If you need to create diskettes
to install the software, see
Appendix A in your
Administrator's Guide , then
use this Setup Guide for
configuration instructions.
For TCP/IP networks, if you
want to use the arp command
to set the card's IP address
instead of installing EPSON
Net!2, see page 28.
2

Install the Network Software

To configure the Ethernet card, you only need to install the
network software (EPSON Net!2) on one workstation or on the
server, depending on your network.
If you have a TCP/IP network, you need to install EPSON
Status Monitor 2 on all your Windows 98 and Windows 95
workstations to use the EPSON TCP/IP Printing protocol.
Log in as an Administrator (NT) or Supervisor (NetWare).
Before you start, turn off all other active applications, including
virus protection.
Installing EPSON Net!2
If you have the following network configurations and operating
systems, you should install EPSON Net!2 to configure the card:
Windows 98, Windows 95, or Windows NT 4.0 with
Novell NetWare or TCP/IP
Macintosh with AppleTalk

Installing EPSON Net!2 in Windows

1. Insert the EPSON Stylus COLOR 850Ne CD-ROM in
your drive.
Setup Guide: Install the Network Software
11