Epson Stylus Color 850Ne Setup Manual page 31

Epson stylus color 850ne: setup guide

Hide thumbs Also See for Stylus Color 850Ne:

Table of Contents

Note:

If you have connected more

than one printer with the

same type of Ethernet card

to the network, you can

distinguish the cards by their

MAC addresses. Press and

hold the card's status sheet

button for three seconds.

See page 10 for details.

To use RARP, BOOTP, or

DHCP, a server for each

protocol is necessary. If

there is no corresponding

server, do not use any of

these settings. See your

network operating system

documentation for the

settings.

3. Click the printer where you want to set the IP address, and

then click the

Configuration

4. Click the

TCP/IP

5. Under The way of acquiring an IP address, select one of the

following:

Manual

Setup Guide: Configure the Printer

button.

tab to display the TCP/IP menu.

, or

RARP

BOOTP

click here

DHCP

Table of Contents