Xerox Nuvera 100 Getting Started Manual page 9

Emergency Power Off
Electrical Supply
Disconnect device
Xerox Nuvera Getting Started Guide
Do not place the Xerox Nuvera Printer where people may step or trip
on the power cord. Do not place objects on the power cord.
Do not override or disable electrical or mechanical interlocks.
Do not obstruct the ventilation openings. These openings prevent
overheating of the machine.
Never push objects of any kind into slots or openings on this
equipment. Making a contact with a voltage point or shorting out a
part may result in fire or electrical shock.
If any of the following conditions occur, immediately switch off the
power to the machine and disconnect the power cord from the
electrical outlet. Call an authorized Xerox service representative to
correct the problem.
The machine emits unusual noises or odors.
The power cord is damaged or frayed.
A wall panel circuit breaker, fuse, or other safety device is tripped.
Liquid is spilled into the Xerox Nuvera Printer.
The machine is exposed to water.
Any part of the machine is damaged.
This product shall be operated from the type of electrical supply
indicted on the product's data plate label. If you are not sure that your
electrical supply meets the requirements, please consult a licensed
electrician for advice.
: This equipment must be connected to a protective earth
WARNING
circuit. This equipment is supplied with a plug that has a protective
earth pin. This plug will only fit into an earthed electrical outlet. This is
a safety feature. If you are unable to insert the plug into the outlet,
contact a licensed electrician to replace the outlet.
Always connect equipment to a correctly grounded power outlet. If in
doubt, have the outlet checked by a qualified electrician.
The power cable is the disconnect device for this equipment and is
attached to the back of the machine as a plug-in device. To remove all
electrical power from the machine, disconnect the power cable from
the electrical outlet.
5