Table of Contents
Advertisement
16
www.electrolux.com
5. INSTALLATION
5.5 Install the bracket
Bracket parts
Sliding rail
holder cover
Soap tray
Soap tray holder
1.
Find a proper place to drill two holes
(5.5mm diameter) in the vertical direction
with 425±1mm distance (Fig 9).
Fig. 9
WARNING!
Check if there is any buried pipes or
cables before drilling.
Wall plug
Sliding seat
Screw
release button
Sliding Seat
Sliding rail
Sliding rail holder
NOTE:
proper position for the bracket if necessary.
3.
Put the wall plugs on the holes, then
remove the sliding rail holder covers from
sliding rail holders on the upper position,
then replace the sliding rail holder cover.
NOTE:
point the opening downward (see Fig. 10).
Fig. 10
4.
To install the assembly of the sliding rail.
a. Assemble the sliding seat into the sliding
rail from the top of the sliding rail. The
release button should be pointing upward,
when installing the sliding seat(see Fig 11).
Fig 11
Sliding rail
(without a hold)
Sliding rail bottom
(with a hold)
Advertisement
Table of Contents
