Table of Contents
Advertisement
5. INSTALLATION
Fixing the front cover
5.4
1. Before fixing the front cover to the shower,
tighten the 3 screws to fix the shower on the
wall firmly.
2. Adjust the spline spindle and the control
knob to the correct position before replacing
the cover Fig. 7a, 7b show the correct pline
spindle and the control knob position.
3. Reassemble the water inlet cover Fig. 8a
and reconnect the cable Fig. 8b.
Fig. 8a
Fig. 7a
Fig. 7b
Water flow position.
T
T
Temperature
Temperature
Temperature
Fig. 8b
4. Check to ensure that the wiring is not
trapped and replace the cover squarely to
the backplate and guide into position so that
the knobs locate correctly into the splined
the points above.
5. While applying slight pressure to the cover,
secure in position with the retaining screws.
6. Once you place the front cover on the
the 4 screws.
Stabiliser valve
2.
ENGLISH
1.
Turn the stabiliser valve
spindle fully clockwise
until resistance is felt.
Turn the temperature
control knob fully
clockwise to the Minimum
15
Advertisement
Table of Contents
