Problem solving guide
Messages in the display
Message
000
Finish/Cooling down
Clean the fluff and
plinth filters. See the
operating instruction
manual for more in-
formation.
Fill the condensate
container with water
Please open and
close the door
68
Cause and remedy
Access via a code has been activated.
Enter the code and confirm the entry. Deactivate
the code if you do not wish this message to ap-
pear in the display the next time the appliance is
switched on.
The laundry will be cooled down at the end of the
programme.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
The tumble dryer is not working correctly or econom-
ically. Possible causes could be clogging caused by
fluff or detergent residue.
To deactivate the message, confirm with
Please see "Cleaning and care" for notes on clean-
ing.
Clean the fluff filters.
Also check the plinth filter and clean it if neces-
sary.
You can influence when the
ters. See the operating instruction manual for more inform-
ation.
message lights up.
To do this, follow the instructions in "Airways indic-
ator – Settings".
The condensed water container is empty. When cer-
tain programmes are being used, water is taken from
the condensed water container and recycled.
To deactivate the message, confirm with OK.
Fill the condensed water container to at least the
―min― mark.
This is to remind you to load the laundry when the
programme is selected.
Steam care
Load the laundry in the drum.
OK
Clean the fluff and plinth fil-
.