Grimac TERRY OPALE Capsule Operating Instructions Manual page 27

7. aCCessOrIes OpTIONal Terry Opale
Capsule vapOr - Terry Opale Capsule Cap
In the Vapor and Cap machines it is possible to install the Cap-
puccinatore and the steam wand as they are not supplied with
the machine.
Before installing or replacing machine parts,
make sure the machine is disconnected from
the power supply and it is cold. Danger of
scalding.
DO NOT use the machine to dispense steam if
the devices are not mounted.
7.1. Cappuccinatore
(Terry Opale Capsule vapor)
In the Opale Vapor machine it is possible to install the Cappuc-
cinatore (sold separately as an accessory).
• (Fig.14a) - Turn the steam wand clockwise to a vertical po-
sition upwards.
• Remove the steam wand by pulling it outwards.
• (Fig.14b) - Insert the Cappuccinatore by pushing it fully
into the fitting.
After having correctly installed the Cappuccinatore, you can
proceed to the preparation of a cappuccino as described in sec-
tion 5.5.
7.2. steam Wand
(Terry Opale Capsule Cap)
In the Opale Cap machine it is possible to install the steam
wand (sold separately as an accessory).
• (Fig.14b) - Remove the Cappuccinatore by pulling it out-
wards.
• (Fig.15a) - Check that the steam wand is equipped with the
relevant spring.
• (Fig.15b) - Insert the steam wand by pushing it fully into
the fitting. The steam wand must be inserted pointing
down.
Warning: The steam wand must be fully in-
serted into its seat. It can come out due to
pressure.
After installing the steam wand, beverages can be heated and
milk can be frothed as described in section 5.4.
27