Epson PictureMate Start Here Manual page 2

2
Install the Photo
Cartridge
1
Open the cartridge door on the back of PictureMate.
You see the release lever.
2
Move the lever to the Release position by sliding it
in the direction shown.
3
Shake the photo cartridge a few times in its package,
then unwrap the cartridge.
4
Slide the cartridge straight into the slot, label side up,
until it is fully inserted. Push in both sides evenly to
make sure it is not crooked.
Caution:
or ink may leak. If either side is sticking out, remove the
cartridge and reinstall it.
5
Move the lever right to the Lock position. If it does
not lock in place, the cartridge is not installed
correctly. Release it and try again.
Make sure both sides of the cartridge are even,
Right
Release lever
To release lever
Wrong