Loading Paper; Safety Approvals; Photo Cartridge - Epson PictureMate Product Information

PictureMate
Power
consumption Approx. 13 W
Approx. 4 W in standby mode
Environmental
Temperature
Operation 50 to 95 °F (10 to 35 °C)
−
Storage* 4 to 104 °F (
1 month at 104 °F (40 °C)
Transit* –4 to 140 °F (–20 to 60 °C)
120 hours at 140 °F (60 °C)
Humidity (without condensation)
Operation 20 to 80% RH
Storage* 5 to 85% RH
* Stored in shipping container

Safety Approvals

Safety standards UL 1950, CSA C22.2 No. 950
EMI FCC part 15 subpart B class B
CSA C108.8 Class B

Photo Cartridge

Colors Black, Cyan, Magenta, Yellow, Red, and Blue
Cartridge life 2 years from production date (if unopened)
(within 6 months after opening package, at
77 °F [25 °C])
−4 to 104 °F (−20 to 40 °C)
Storage temperature
1 month at 104 °F (40 °C)
−22 to 140 °F (−30 to 60 °C)
Transit temperature
1 month at 104 °F (40 °C)
120 hours at 140 °F (60 °C)
Freezing temperature* 12.2 °F (−11 °C)
7.7 × 3.6 × 0.7 inches (W × D × H)
Dimensions
196 × 91.5 × 18.8 mm (W × D × H)
* Ink thaws and is usable after approximately 3 hours at
77 °F (25 °C).
Caution: To ensure good results, use a genuine PictureMate Photo
Cartridge and do not refill it. PictureMate calculates the amount of ink
remaining using an IC chip on the photo cartridge, so even if the
cartridge is refilled, the IC chip will report that it is empty.
Do not use a photo cartridge if the date on the cartridge has expired.
Do not leave PictureMate, a PictureMate Photo Cartridge, or
PictureMate with a PictureMate Photo Cartridge installed exposed to
heat or direct sunlight.
PictureMate
2 -
−
20 to 40 °C)

Loading Paper

Follow these steps to load PictureMate Photo Paper.
Caution: Don't load plain paper; this may damage PictureMate.
1. Move the handle to the back and down.
Move handle
to the back
and down
Open output tray
Note: Keep the handle to the back and all the way down, to
allow paper to feed through.
2. Open the output tray.
3. Open the paper support. Slide the top part of the paper
support up gently until it clicks into place.
Load
glossy side
up
4. Place your paper against the right edge, glossy side up.
Note: Make sure paper is glossy side up to prevent smearing.
5. Slide the edge guide against the paper. Make sure it is snug,
but not so tight that paper is bent.
Edge
guide
Printing
PictureMate can print photos from these devices:
Your digital camera's memory card.
A data storage device, such as a CD, Zip disk, or flash
memory (thumb) drive. See the Using PictureMate Without
a Computer book for details.
A PictBridge- or USBDP-enabled digital camera. See the
Using PictureMate Without a Computer book for details.
4/04
Open and
slide up
paper support