Advertisement
6. COMPLIANCE WITH STANDARDS
Compliance with Standards
EN 50131-1 Security Grade
EN 50131-1 Environmental Class
FCC Compliance Statement
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio and
television reception.
However, there is no guarantee that interference will not occur in a particular installation. If this device does cause such interference, which can
be verified by turning the device off and on, the user is encouraged to eliminate the interference by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one that supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipmen
t.
This device complies with FCC Rules Part 15 and with Industry Canada licence-exempt RSS standard(s). Operation is subject to two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference that may be received or that may cause undesired operation
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisee aux deux conditions
suivantes :(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est
susceptible d'en compromettre le fonctionnement.
The technical documentation as required by the European Conformity Assessment procedure is kept at:
UNIT 6 MADINGLEY COURT CHIPPENHAM DRIVE KINGSTON MILTON KEYNES MK10 0BZ. TEL.: +44(0)845 0755800 FAX: +44(0)845 0755801
W.E.E.E. Product Recycling Declaration
For information regarding the recycling of this product you must contact the company from which you orignially purchased it. If you are discarding this product and not
returning it for repair then you must ensure that it is returned as identified by your supplier. This product is not to be thrown away with everyday waste.
Directive 2002/96/EC Waste Electrical and Electronic Equipment.
APPENDIX: SPECIFICATIONS
GENERAL
Detector Type
Lens Data
Max. Coverage
Pet Immunity (Next CAM-K9 PG2
only)
ELECTRICAL
Internal Battery
Nominal Battery Capacity
Low Battery Threshold
Battery Life (for typical use)
D-302893 NEXT CAM PG2, NEXT CAM-K9 PG2 Installation Instructions
Europe: Directive 1999/5/EC of the European Parliament. EN 50131-1 Grade 2 Class II. EN 50131-2-2, EN 50131-6
Environmental IP55.
The NEXT CAM PG2 and NEXT CAM- K9 PG2 are compatible with the RTTE requirements - Directive 1999/5/EC of the
European Parliament and of the Council of 9 March 1999 and EN50131-1 Grade 2 Class II.
Certified by the Dutch testing and certification body Telefication BV to the following standards :
EN 50131-2-2, EN 50131-6, EN 50131-5-3, EN 50130-4, and EN 50130-5.
Telefication BV has certified only the 868 MHz variant of this product.
USA: Designed to meet FCC Part 15
UK: This product is suitable for use in systems installed to conform to PD6662:2010 at Grade 2 and environmental class 2.
DD243 and BS8243
Canada: RSS 210
The Power G peripheral devices have two- way communication functionality, providing additional benefits as described in
the technical brochure. This functionality has not been tested to comply with the respective technical requirements and
should therefore be considered outside the scope of the product's certification.
According to EN 50131-1:2006 and A1:2009, this equipment can be applied in installed systems up to and
including Security Grade 2.
Class II
Dual element low-noise pyroelectric sensor
No. of Curtain Beams / curtains:
Next CAM PG2: 18 far, 18 mid, 10 close.
Next CAM-K9 PG2: 18 far, 18 mid, 18 close.
Note: Lens – Reflex II PIR, Fresnel type lens With Optical
attenuation in the lower part of the lens. Lens material is High
Density Polyethylene (HDPE). Part of Enclosure Cover (Item 1) and
snapped to the Enclosure Base (Item 2) by two tabs and one screw.
12 x 12 m, (40 x 40 ft) / 90°
A. HORIZONTAL VIEW
B. VERTICAL VIEW
C. Next CAM PG2: 0.5-4m, Next CAM-K9 PG2: 2-4m
Up to 38 kg (85 lb)
6V Lithium battery (two CR-123A 3V batteries or two CR17450 3V batteries, in series) or equivalent.
Notes:
1. Use only the above battery type.
2. For UL installations use Gold Peak (GP) CR123A only.
6V 1450 mA/h (2xCR123A), 2200 mA/h (2xCR17450)
4.5 V
4 to 5 years (CR123A) / 8 years (CR17450)
.
9 (30ft)
6 (20ft)
90°
A
3 (10ft)
0
3 (10ft)
6 (20ft)
9 (30ft)
0
3
6
9
10
20
30
B
2.4 m
(8 ft)
C
0
3
6
9
10
20
30
Fig. 5. Coverage Pattern & Walk-test
12 m
40 ft
12 m
40 ft
5
Advertisement
