Standard Repairs - Problems And Remedies; Regular Maintenance Summary Table - Etesia NECTS User Manual

10• STANDARD REPAIRS - PROBLEMS AND REMEDIES
Most operating problems are due to wrong handling and using, poor use of the lawnmower or the lack of normal recommended maintenance.
The following table describes simple methods of determining a few malfunctions and correcting them.
If the problem persists, we recommend that you contact one of our approved ETESIA dealers (list on requist to ETESIA - 67165
WISSEMBOURG Cedex - France).
Before doing anything, disconnect the power cable.
ANORMAL OPERATION
Uneven running, strong vibrations.
Poor cutting.
The lawnmower is difficult to
engage in gear or disengage.
The grass box fills badly.
Grass remains.
Important: Only use ETESIA parts as replacements. The quality of the work, the life of the lawnmower and your safety
depend on it.
In addition to risks incurred by the user, the use of parts other than the manufacturer's will result in the cancellation of the warranty for any
damage caused. ETESIA refuse to accept responsibility for accidents due to the use of parts not coming from the manufacturer.
11• REGULAR MAINTENANCE SUMMARY TABLE
Disconnect the power cable before carrying out any work under the cutting deck.
ITEM
Coupling washer
Drive clutch
Blade
Cables
Screws
The best maintenance is regular cleaning after each mowing (cutting deck, wheels, engine, cutting heights, transmission system,...).
16
PROBABLE CAUSE
Blade balance .................................................................Rebalance or replace the blade.
Cutting blade loose ........................................................Tighten the attaching screw.
Coupling washer defective .............................................Have replaced.
Blade mounted upside down. .........................................Refit with blade surfaces facing the engine.
Blunt blade .....................................................................Sharpen or change.
Blade not turning in a horizontal plane.. ........................Straighten or change.
Wrong choice of cutting height ......................................Match the cutting height to the working conditions.
Wrong adjusted or stretched clutch cable ......................Contact an approved ETESIA service engineer.
Defective blade or mounted upside down. .....................Replace or refit correctly.
Cutting too low ..............................................................Change the cutting height.
Blocked grass box grille .................................................Clean with a brush.
Opening and housing blocked by cuttings and earth .....First disconnect the electric cable and then
Height adjustment too low .............................................Adjust the deck cutting height lever.
Opening and housing blocked by cuttings and earth .....First disconnect the electric cable and then
BEFORE EVERY CUT EVERY 50 HOURS
Check condition
Check condition
Check condition
REMEDY
clean the housing.
clean the housing.
PERIODICALLY COMMENTS
Replace after strong
shock
Clean and check the Maintain perfectly clean
cable adjustment
Replace after strong shock
Check tightness