Epson LQ-860 User Manual page 228

Problem
Using the cut sheet
feeder, the paper
does not feed
properly
(continued).
After a print command
is sent from the
computer, the platen
rotates, but paper does
not feed. The PAPER
OUT light is on.
7-28
Troubleshooting
Solution
DIP l-7 is set to off. DIP switch
switch
must be set to on in order to use the cut
sheet feeder. See Chapters 3 and 5.
The cut sheet feeder may be incorrectly
installed on the printer. Remove and
reinstall the cut sheet feeder making sure
that the mounting notches are properly
mated with the pins on the printer. See
Chapter 5.
The cut sheet feeder may be out of paper.
Load more paper in the cut sheet feeder's
bin.
The paper release lever may not be in the
single-sheet position. Push the lever all
the way back to the single-sheet position.
See Chapter 5.
The paper set levers on
feeder may be pulled forward. After
loading a stack of paper in the cut sheet
feeder, push the paper set levers
backward. See Chapter 5.
the cut sheet
l-7