Adjusting Parking Brake - Kubota ZG222A Operator's Manual

58 PERIODIC SERVICE
A Take care not to damage and misplace the element
and packing.
A If they are excessively dirty (clogged), they will be
clogged again in short hours after cleaning.
4. Reassemble the packing and element while taking
care that they are not contaminated with dirt.
A If dirt is included in fuel, a failure can result.
A If the carburetor fuel valve is moved to the "DRAIN"
position, the fuel will be drained through the drain port.
(1) Carburetor fuel valve
(2) Drain port
(A) "STOP" (CLOSE)
(B) "RUN" (OPEN)
(C) "DRAIN"
BAdjusting Parking Brake
If you feel you are unable to make the following service
correctly and safely, contact your local KUBOTA Dealer.
To avoid personal injury:
A Park the machine on a firm and level surface.
A Stop the engine and chock the wheels before
checking or adjusting.
A Wrong adjustment may cause machine damage.
(1) Check brake spring
1. Place the motion control levers to the "NEUTRAL
LOCK" position.
2. Be sure to chock the rear wheels.
3. Apply the parking brake to the lock position.
4. Check the length of the brake springs on both sides.
(A): Proper brake spring length
with the brake applied to the
lock position
(1) Brake rod (A) "Parking brake spring length"
(2) Brake spring
(3) Lock nut
5. If the length of the brake spring is not correct, adjust it.
(See "Adjustment of brake spring length" below.)
115 to 117 mm
(4.53 to 4.61 in.)