Checking Movable Parts; Every 50 Hours; Checking Engine Start System - Kubota ZG222A Operator's Manual

(1) Spindle shaft
(2) Belt tension pulley
(3) Belt tension pivot
(4) Anti-scalp roller (Grease the bosses.)
BChecking Movable Parts
If any of the movable parts, such as levers and pedals, is
not smoothly moved because of rust or anything sticky, do
not attempt to force it into motion.
In the above case, remove the rust or the sticky thing, and
apply oil or grease on the relevant spot.
Otherwise, the machine may get damaged.
PERIODIC SERVICE

EVERY 50 HOURS

BChecking Engine Start System
The Engine Start System in your machine is designed to
protect you while operating. Check the Engine Start
System periodically. It is recommended to check the
Engine Start System before daily operation.
To avoid serious injury or death:
A Do not allow anyone near the machine while
testing.
A If the machine does not pass one of the
following tests, do not operate the machine.
See your local KUBOTA Dealer.
A Sit on operator's seat for all tests except for
Test 1.
A Check the following tests before operating the
machine.
(1) Parking brake lock pedal
(2) Motion control lever
(3) Key switch
(4) PTO lever
(5) Seat switch
Test 1 (OPERATOR NOT ON THE SEAT)
1. Securely set the parking brake.
2. Shift the PTO lever to "DISENGAGE" (OFF) position.
3. Set the motion control levers to the "NEUTRAL LOCK"
position.
4. Turn the key switch to "START" position.
5. The engine must not crank.
Test 2 (OPERATOR ON THE SEAT)
1. Do not set the parking brake. (release it from test 1)
2. Shift the PTO lever to "DISENGAGE" (OFF) position.
3. Set the motion control levers to the "NEUTRAL LOCK"
position.
4. Turn the key switch to "START" position.
5. The engine must not crank.
47