Marantz SR7013 Owner's Manual page 147

Contents Connections
Direct playback
Sound recorded in source is played as is.
1
Press PURE to select "Direct".
Direct playback begins.
0 While DSD signals are played back, "DSD Direct" is displayed.
0 This can also be set by pressing PURE DIRECT on the main unit.
Front panel Display
Playback Settings
Pure Direct playback
This mode is for playback with higher sound quality than in Direct playback
mode.
This mode turns off the main unit display and analog video circuit. Doing
so suppresses noise sources that affect sound quality.
1
Press PURE to select "Pure Direct".
The display goes dark, and Pure Direct playback begins.
The PURE DIRECT indicator lights.
0 In Direct and Pure Direct sound modes, the following items cannot be adjusted.
0 Tone (v p. 141)
0 M-DAX (v p. 190)
0 MultEQ
0 Dynamic EQ (v p. 194)
0 Dynamic Volume (v p. 195)
0 Graphic EQ (v p. 196)
0 This can also be set by pressing PURE DIRECT on the main unit.
NOTE
0 Video signals are only output when HDMI signals are played in the Pure Direct
mode.
0 When the Pure Direct mode has been selected, the display turns off after about 5
seconds.
147
Rear panel
Tips
® XT32 (v p. 193)
Remote Index
Appendix