Supermicro SuperServer 7089P-TR4T User Manual page 75

VGA Enable
Jumper JPG1 allows the user to enable or the VGA support in your system. The default setting
is "1-2" to enable the connection. Refer to the table below for jumper settings.
Manufacturer Mode Select
Close pin 2 and pin 3 of Jumper JPME1 to bypass SPI flash security and force the system
to operate in the Manufacturer mode, allowing the user to flash the system firmware from
a host server for system-setting modifications. Refer to the table below for jumper settings.
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor that can reset the system when a software application
hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3 to generate
a non-maskable interrupt signal for the application that hangs. Refer to the table on the below
for jumper settings. Watch Dog must also be enabled in the BIOS.
VGA Enable
Jumper Settings
Jumper Setting Definition
1-2 Enabled (Default)
2-3 Disabled
ME Mode Select
Jumper Settings
Jumper Setting Definition
1-2 Normal (Default)
2-3 Manufacturer Mode
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset (Default)
Pins 2-3 NMI
Open Disabled
75
Chapter 4: Board Connections