Partial Minipool Empty Test - treesse Zen Pro Installation Manual

First run
MANUAL BACKWASHING
9
In Treesse minipools the backwashing is automatic,
running automatically every 48 hours of use of the
minipool, but can be forced manually:
A Press the "OK" key 6 for at least three seconds.
B this provides access to a submenu page.
C Use the + and - keys until the "BACKWASH"
9 icon is illuminated and press the "OK" key
6 to activate it.
SILENCE MODE (SILENT HOURS)
10
This function provides access to a page where the
hours of the day can be specified during which the
control enters SILENCE operating mode (silent
hours), when all the automatic activations of the
pumps and/or blowers are inhibited and only the
antifreeze safety function remains active.
More precisely:
• If an automatic function is active when the SILENCE
function is engaged, it is deactivated immediately
(except for antifreeze).
• If a user function (whirlpool or blower) is active when
the SILENCE function starts, the SILENCE function
remains suspended and will become active 10
minutes after the user function has been switched off.
• If a user function is activated by the user while the
SILENCE function is active, the latter is suspended
(and heating and filtering is re-enabled) and will be
reactivated 10 minutes after the last user function
has been switched off.
• If the temperature set point is changed during the
SILENCE function, the new value will become valid
at the end of the function.
The CHROMATHERAPY function 5 is not affected
•
by the SILENCE function.
• The maximum duration of the SILENCE function is
20 hours (even non-consecutive) in order to maintain
the water temperature at the set value and to ensure
filtering.
3

PARTIAL MINIPOOL EMPTY TEST

The minipool can be drained at any time, without people inside the minipool.
Perform a brief test to verify that the water is correctly drained.
To activate emptying:
A Press the "OK" key for at least three seconds.
B this provides access to a submenu page.
C Press the "EMPTY" 7 key.
During emptying of the bathtub, the only enabled function is chromatherapy.
To stop the drain test, press the "EMPTY" key again.
Once the test is finished, refill by pressing the key
EN
How to set the SILENCE function:
A Press the "OK" 6 key for at least three seconds.
B this provides access to a submenu page.
+ and - keys until the "SILENCE" 10
C Use the
icon is illuminated and press the "OK" key 6 to
activate it.
D With the + or - key move to the hour boxes.
E Press the "OK" key to enable the "SILENCE" mode
schedule:
White box: silence mode disabled
Grey box: silence mode enabled (recirculation
inactive)
-
0 1
6 7
12 13 14
18 19 20
DISABLE
EXAMPLE
Silent hours highlighted in the table: silent mode acti-
vated from midnight to 7 am and from 3 pm to 4 pm
DISABLE (white boxes): silence mode disabled
ENABLE (dark boxes): silence mode enabled (recircula-
tion inactive)
After six seconds during which no key is touched the
configuration is memorised and the water temperature
is displayed again.
.
20
Zen Pro
minipool
+
2 3 4 5
8 9 10 11
15 16 17
21 22 23
ENABLE