7. Reinstall the developer cartridge.
8. Press down the printer cover until it clicks shut.
9. When turning on the printer, access the printer settings dialog
box in the printer driver, and click the OPC Level Clear
button. The OPC level clear dialog box is displayed.
10. Click OK to reset the Photoconductor level counter.
Cleaning the Printer
The printer needs only minimal cleaning. If you notice a decline
in print quality, clean the inside of the printer as described in this
section.
You should also clean the paper cassette and the printer cover
every few months. These procedures are described later in this
section.
Cleaning the inside of the printer
Fine particles of dust can collect inside the printer. Follow the
steps below to clean the inside of the printer and the paper feeder:
1. Make sure the printer is turned off.
2. Open the printer cover.
w
Warning:
Opening the printer exposes the fuser, which is marked
CAUTION Hot Surface Avoid Contact.
3. Remove the developer cartridge and the photoconductor unit
as each are described in "Replacing Consumable Products"
on page 5-2.
Maintenance and Transportation
5
5-9