Moving To Another Time Zone; Stopwatch; Split Times And Lap Times; Measuring Elapsed Time - Casio 5659 Operation Manual

Moving to Another
Time Zone
Use the procedure below to easily change day
and time settings of the watch to a destination
location.
Before Boarding
●
1.
Configure the World Time to the current
time at your destination.
Current time
Destination time
Using BABY-G Connected to
l
Configure Settings
Using Watch Operations to Configure
l
Settings
2.
Disable auto time adjustment.
Using the Watch in a Medical Facility or
l
Aircraft
After Arriving
●
1.
Swap the origin time zone time with the
destination time zone time.
Before swapping After swapping
Destination time
Destination time
Using BABY-G Connected to
l
Configure Settings
Using Watch Operations to Configure
l
Settings
2.
Enable auto time adjustment.
Using the Watch in a Medical Facility or
l
Aircraft
3.
Adjust the time setting.
Triggering Immediate Time Adjustment
l
Watch Operation Guide 5659
The Stopwatch Mode lets you measure up to
60 minutes in one-second units.
In addition to normal elapsed time
measurements, the stopwatch also lets you
take split time and lap time readings.

Split Times and Lap Times

Split time
●
A split time is the time elapsed from the start,
up to any point along the course of an event.
Lap time
●
A lap time shows the time elapsed during a
specific lap around a track, etc.

Stopwatch

D
Start
Split 1
A
Split 2
A
Split 3
D
Goal
D
Start
Lap 1
A
Lap 2
A
Lap 3
D
Goal

Measuring Elapsed Time

1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
Minutes, seconds
2.
Use the operations below to measure
elapsed time.
Start
Stop
Resume
Stop
3.
Press (A) to reset the stopwatch to all
zeros.

Measuring a Split Time

1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
If a lap time measurement operation is
●
displayed, clear it before proceeding to
step 2.
Measuring Lap Times
l
2.
Press (A) to display [SPL].
Each press of (A) toggles between
●
[SPL] (split time) and [LAP] (lap time).
Minutes, seconds
3.
Use the operations below to measure
elapsed time.
Pressing (A) displays the elapsed time
●
up to that point (split time), alternating
with [SPL] for about eight seconds.
D
Start
A
Split
D
Stop
4.
Press (A) to reset the stopwatch to all
zeros.
19