Epson ActionPrinter 4000 User Manual page 199

Problem
Using the cut sheet
feeder, the paper
does not feed
properly
(continued).
After a print command
is sent from the
computer, the platen
rotates, but paper does
PAPER
not The
feed.
OUT light is on.
Solution
DIP switch 1-8 is set to off. DIP switch 1-8
must be set to on in order to use the cut
sheet feeder. See Chapters 3 and 5.
The cut sheet feeder may be incorrectly
installed on the printer. Remove and
reinstall the cut sheet feeder making sure
that the mounting notches are properly
mated with the pins on the printer. See
Chapter 5.
The cut sheet feeder may be out of paper.
Load more paper in the cut sheet feeder's
bin.
The paper release lever may not be in the
single-sheet position. Push the lever back
to the single-sheet position. See Chapter 5.
The paper set levers may be pulled
forward. After loading a stack of paper in
the cut sheet feeder, push the paper set
levers backward. See Chapter 5.
The left and right paper guides may be
too close together, preventing smooth
paper feed. Adjust the position of the
paper guides so that the paper can move
up and down freely. See Chapter 5.
Troubleshooting
Options
7-25