Section 3
Installation and Connections
Installation
Reader/Writer
V680S-HMD64-ETN
Install the Reader/Writer with four M4 screws. Use both spring washers and flat washers.
M4 screw
Spring washer
Flat washer
When you install the Reader/Writer, please have the bracket as shown in the figure below.
Material: Steel, SUS
Although it is possible to use aluminum in addition to iron and copper as a mounting bracket, communication
performance will change depending on the material. Please do not use resin as a mounting bracket.
The recommended tightening torque for M4 screws is 1.2 N·m.
Refer to Reader/Writer Installation Precautions in Section 8 Appendices for information of surrounding metal and
Mutual Interference of Reader/Writers.
RFID System
60
User's Manual
Four, M4 hole
65
±0.2
75
(Unit: mm)
p.207
Mounting Hole Dimensions
Four, M4 holes
65±0.2
V680S-HMD64-ETN
Screw mounting
Bracket
(Unit: mm)