Table of Contents
Advertisement
Extended maintenance work
4.2 Opening the device and loosening cables
4.2
Opening the device and loosening cables
Requirement
● The device has been removed from the stand or support arm.
● The connection cables have been removed from the device interfaces.
● Required tool: Allen wrench, size 8 mm
Procedure
1. Place the device on its front. Use a soft and elevated surface so that the device front
does not contact the working area, and the front and any operator controls on the front, if
present, are not damaged.
2. Remove the 20 screws that connect the rear panel with the device front.
3. Lift the rear panel on the right and fold it back to the left, as shown in the figure below.
Make sure that the rear panel seal remains in the device front.
12
SIMATIC IPC277D/E 19" INOX PRO, SIMATIC IFP1900 INOX PRO
Service Manual, 11/2017, A5E35751762-AC
Advertisement
Table of Contents
