Table of Contents
Advertisement
Overview
The INOX PRO devices are available with or without operator controls on the front and are
intended for "stand mounting" or "support arm mounting". The figure below shows the front
view using a device with operator controls as an example.
①
Illuminated pushbutton
②
Illuminated pushbutton
③
EMERGENCY OFF button
④
Mounting kit for stand mounting
This document describes the following maintenance work:
● Replacing the seal of the compartment cover
● Replacing defective operator controls in the device front and LEDs
● Replacing the seal of the rear panel
● Changing the mounting type, which means converting a device for stand mounting into a
device for support arm mounting and vice versa.
Only for devices with operator controls
1
SIMATIC IPC277D/E 19" INOX PRO, SIMATIC IFP1900 INOX PRO
Service Manual, 11/2017, A5E35751762-AC
"left" with green LED
1
"right" with red LED
1
1
⑤
Terminal compartment cover with seal
⑥
Rear panel with seal
⑦
Mounting kit for support arm mounting
1
1
5
Advertisement
Table of Contents
