Before Installation - England's Stove Works 50-SNC30 Installation & Operation Manual

If you have any doubt concerning your ability to complete your installation in a professional-like
manner after reading these instructions, you should obtain the services of an installer who is versed in
all aspects as to the correct and safe installation. Do not use temporary, makeshift compromises
during installation.
BEFORE INSTALLATION OF YOUR APPLIANCE
HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE
1.
AWAY. CONTACT MAY CAUSE SKIN BURNS.
DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS.
2.
Check with the building inspector's office for compliance with local codes; a permit may be
3.
required.
This appliance requires a masonry or prefabricated chimney listed to ULC S629 (Canada) and
4.
UL103HT (U.S.) sized correctly.
A 6" diameter flue is required for proper performance.
5.
Always connect this unit to a chimney and NEVER vent to another room or inside a building.
6.
DO NOT connect to any duct work to which another appliance is connected, such as a
7.
furnace.
DO NOT connect this unit to a chimney flue serving another appliance.
8.
DO NOT USE CHEMICALS OR FLUIDS TO START THE FIRE.
9.
The connector pipe and chimney should be inspected periodically and cleaned if necessary.
10.
Remember the clearance distances when you place furniture or other objects within the area.
11.
DO NOT store wood, flammable liquids or other combustible materials too close to the unit.
Contact your local fire authority for information on how to handle a chimney fire. Have a
12.
clearly understood plan to handle a chimney fire. In the event of a chimney fire, turn air control
to a closed position and CALL THE FIRE DEPARTMENT.
DO NOT tamper with the combustion air control beyond normal adjustment.
13.
Once the required draw is obtained, operate only with doors closed; open doors slowly when
14.
re-fueling (this will reduce or eliminate smoke from entering the room).
Visit our web site at
15.
questions, parts/accessory orders and more. Customer Service: (800) 245-6489.
Note on Outside Air Hookup: You can use an outside air hookup with this unit. We highly recommend it for
homes built since the more air-tight construction standards went into effect. This involves connecting a metal pipe
(usually three inches (3") in diameter - check your stove - and the pipe can be flex or rigid) from the air inlet pipe
located on the bottom rear of the stove through your floor or wall. The outside end of this pipe should be covered
in some manner (i.e. with a screen) to keep it clear of foreign matter. Be sure to keep it above the snowdrift line
and clear of leaves and other debris. It is necessary to use this hookup if installing in a mobile home or
double-wide – See "Outside Air Connection" section of manual.
A kit is available from England's Stove Works, Inc. designed for connecting this unit to outside
combustion air. [Part No. AC-OAK3]
CAUTION
www.heatredefined.com for helpful information, frequently asked
5